Track-mounted sliding gate
The leaf runs on a rail set into the ground or a track at the base. It needs a clear run beside the opening and a track that stays clean; it suits villas, compounds and light commercial entrances where space allows.
Track, cantilever and telescopic sliding gates for villas, compounds and factories: how to choose the type, how the motor is sized by gate weight, which safety devices belong on the gate, and what it costs.
The type is decided by the space beside the opening, the width and the conditions on site.
The leaf runs on a rail set into the ground or a track at the base. It needs a clear run beside the opening and a track that stays clean; it suits villas, compounds and light commercial entrances where space allows.
The leaf is carried on posts and rollers with no floor rail, so sand and debris cannot jam a track. It needs a longer leaf to balance the overhang and strong posts and foundations.
The leaf is made of stacked sections that slide over one another, so it needs about half the clearance beside the opening. It suits tight sites and premium designs; Quicknet publishes AED 30,000–65,000 and 8–12 seconds to open.
Wide factory, warehouse and labour-camp entrances in Mussafah and ICAD, including gates of 12 m, need a heavy-duty motor and rails sized for the weight and a high duty cycle.
A sliding gate motor is rated by the weight of the leaf it can move, so the survey weighs or estimates the leaf first. Retail listings in 2026 sell sliding motors in classes of 400, 600, 800 and 1,000 kg, from about AED 1,200 supplied (gatesautomatic.com and gateautomationuae.com, read 8 October 2026); heavier industrial gates need heavy-duty motors, which Quicknet publishes at AED 8,000–18,000 excluding the gate.
Choose a motor rated comfortably above the leaf weight, and check the duty cycle: a villa gate opens a few times a day, a compound or factory gate may cycle hundreds of times. An undersized motor wears early and can void the manufacturer's warranty. For villas and small compounds we recommend BENINCA, Nice or CAME kits; for commercial sites, FAAC, MAGNETIC AutoControl, BFT or CAME heavy-duty motors, matched to your weight, traffic and budget at the survey.
A sliding gate needs a straight, unobstructed run along the fence or wall; a cantilever leaf also needs room for its tail.
Level ground, drainage, and a foundation or post base strong enough for the leaf and the motor. Sand and water in the track area are the usual causes of early problems.
The distance from the supply point, the cable route and any trenching; a long driveway in Al Ain or a farm plot may need a longer cable run or a solar or battery supply.
Photocells across the opening, a safety edge on the leading edge, loop detectors where vehicles stop and a manual release for power failures.
Remotes, keypads, intercom, RFID, ANPR or app opening. Rolling-code remotes are harder to copy than fixed-code ones.
Powered gates are normally designed with reference to the European standards EN 12453 (safety in use) and EN 12445 (force testing). UAE Cabinet Resolution No. 37 of 2016 on the safety of automatic doors and windows, which covers barriers and gates, makes the standards in its annex mandatory (what it requires). A sliding leaf can trap or crush, so photocells, a safety edge on the leading edge, correct closing force and a manual release are part of a safe installation, not options.
For emergency access and what the standards say, see the automatic gates page; for what to check when a sliding gate stops, jams or runs slowly, see gate repair and maintenance.
Quicknet publishes these ranges. A band is a range, not a quote, and the final price follows the site survey.
| Item | Published range |
|---|---|
| Automatic sliding gate, installed | AED 12,000–35,000 |
| Telescopic sliding gate, installed | AED 30,000–65,000 |
| Heavy-duty sliding gate motor (CAME / FAAC), excluding the gate | AED 8,000–18,000 |
For what changes the price, motor-only quotes and a quote checklist, see the automatic gate price guide. Swing gates are on the swing gate page. Local detail: Al Ain and Mussafah.
Last checked 8 October 2026. Indicative figures; the written quote after a site survey is what applies. A moving gate can injure; have a qualified technician inspect a faulty one.
Yes. "Gate motor", "gate opener" and "gate operator" are different names for the motor and control unit that moves an automatic gate. Sliding gates use a motor with a pinion on a rack, and swing gates use an arm, ram or underground opener; what matters is that the rating matches the leaf weight and length.
Often yes, if the gate runs freely, sits level on a sound track and its leaf weight is within the motor rating. The survey checks the track, rollers, foundation and leaf weight, and a stiff or sagging gate is repaired first because a motor will only wear out fighting it. Safety devices such as photocells are still added.
A sliding gate motor, also called an operator, is the electric drive unit that pulls the gate leaf along its track or cantilever rail through a pinion that meshes with a gear rack fixed to the leaf. It is rated by the leaf weight it can move and by how many cycles a day it is built for, and it works with a control board, photocells, a safety edge and remotes.
There is no single figure: life depends on the duty cycle, whether the motor is rated above the leaf weight, how well the track and rollers are kept, heat and dust, and servicing. A correctly sized, serviced motor on a free-running gate lasts far longer than an undersized one fighting a stiff track. If repairs keep returning, see our guide on whether to repair or replace a gate motor.
Yes. Quicknet supplies and installs automatic sliding gates with their motors in Abu Dhabi, Mussafah and Al Ain. The motor is sized to the leaf weight and length, which the free site survey measures, and a written quote follows.
Real reviews from the Google Business Profiles of Quicknet Computers across our three branches. Independent integrator since 2012, ISO 9001 and ISO 27001 certified.
Electrical work. Mains-side electrical work and the utility (ADDC in Abu Dhabi, AADC in Al Ain) approval are carried out by a licensed electrical contractor named in the written quote. Quicknet coordinates the project and handles the ELV, IT and security side.
Quicknet Assistant
Common questions
Hi! 👋 I'm the Quicknet Assistant.
I can answer common questions about our services. What can I help you with today?